Problem Possible Cause 1a. Shipping brackets not removed 1b. Machine not leveled 1. Machine 1c. Machine installed on uneven vibrating or floor vibrating noise 1d. Machine installed on wood floor 1e. Rubber cap missing from rear foot 2a. Door not screwed in properly 2.
Problem Possible Cause 1a. No power input. 1b. No water pressure. 1c. Drain outlet below 20" (water siphoning out) 1d. Door not closed tightly 1e. Door Switch/Lock. 1. Won't fill 1f. Pressure Switch. (test with no water in the tub) 1g.
Page 6
6a. Not leveled. 6. Water leaks 6b. Spinning with water in tub. from detergent drawer 6c. Motor (tachometer). 7a. Water supply off. 7b. Filling interrupted. 7. Timer doesn't advance 7c. Timer. 8. Water flows into tub with 8a. Water inlet valves leaking. machine off.
Page 7
11. Clothes wet 11a. Water in tub. at end of wash cycle. 11b. Inadequate final spin. TESTING THE DRIVE MOTOR Check Resistance as under Pin 2 & 6 Pin 3 & 7 Pin 4 & 8 11R9 23R0 (Tachometer) switch and push the metallic plate (latch) forward towards the drum, simultaneously trying to open the door with the other hand.
Page 8
COMPANY INFORMATION EQUATOR CONTACT NUMBERS SERVICE, PARTS, ACCESSORIES & DETERGENT ORDERING: (800) 776-3538 TECHNICAL SUPPORT: (888) 935-1565...