Download Print this page

Toa ES-0422WP Instruction Manual page 4

Advertisement

ABOUT THE COMBINATION WITH OPTIONAL EQUIPMENT
• Matching transformer MT-S0601
To install the MT-S0601 transformer in the speaker system, remove the blank panel located at the back of the speaker
system. For the installation method, refer to the instruction manual attached to the MT-S0601 transformer.
MT-S0601
High impedance
Primary terminal
100 V line
83 Ω
170 Ω
330 Ω
670 Ω
WARNING
• Mounting bracket YS-0421WL
The unit can be mounted to a wall or pole using an optional YS-0421WL mounting bracket. For details, refer to the
instruction manual attached to the mounting bracket.
• Low frequency equalization by digital signal processors
When using TOA's digital processor, by setting its parameter as shown in the
table at right, low frequency characteristics can be corrected.
SPECIFICATIONS
Model No.
Enclosure Type
Power Handling
240 W (continuous program)
Capacity
Rated Impedance
Sensitivity
Frequency Response
Crossover Frequency
Speakers
Low frequency: Two 12cm woofers Low frequency: Four 12cm woofers Low frequency: Six 12cm woofers
Input Terminals
Enclosure Materials
Grill Materials
Dimensions
Weight
Note : The design and specifications are subject to change without notice for improvement.
High impedance
70 V line
60 W
60 W
30 W
30 W
15 W
15 W
7.5 W
Do not open nor repair the inside for disassembly or modification. Because the unit
employs a special splashproof construction, do not loosen nor remove screws other
than those used for holding the blank panel. When replacing the blank panel after
installing the transformer, check to be sure that all screws (6 places) are fitted with
water-preventive washers and that the screws are tightened.
Failure to observe these instructions may cause the speaker to fall, resulting in
personal injuries.
ES-0422WP
80 W (continuous pink noise) 120 W (continuous pink noise) 120 W (continuous pink noise)
91 dB (1 W, 1 m)
High frequency: CD horn + driver (100° horizontal x 50° vertical)
Wood, FRP-coated, urethane paint, white
152 (W) x 436 (H) x 172 (D) mm
8.5 kg
ES-0424WP
Sealed type
360 W (continuous program)
8 Ω
95 dB (1 W, 1 m)
120 Hz – 20 kHz
3 kHz
Directly connected cable (2 cores, 2 m)
SUS304, acryl paint, white
152 (W) x 716 (H) x 172 (D) mm
12.8 kg
TYPE
Freq.
Gain
HPF
60 Hz
PEQ
100 Hz +10 dB
ES-0426WP
360 W (continuous program)
96 dB (1 W, 1 m)
152 (W) x 996 (H) x 172 (D) mm
16 kg
133-01-399-50
Q
0.707
2.871

Advertisement

loading

This manual is also suitable for:

Es-0424wpEs-0426wp