Mediroyal NRX Strap Series Quick Start Manual

NRX Patella Subluxation
®

Material

NRX
1
Cut the main part from the NRX
Strap 110 mm. Make sure to make
the patella hole slightly larger than
the actual size of the patella.
3
Attach the main body around the knee. Position the patella in the hole and attach the straps from the outside, securing them
over the inside.
4
Attach the anchor over the lateral side. Make sure to keep the knee in about 20 degree flexion to slack the patella. Pull the
straps to make sure that the straps catch the patella. Start by attaching the lower strap and then adjust the upper one.
Adjust the tension of the straps if needed.
Mediroyal Nordic AB · Box 7052 · 192 07 Sollentuna · Sweden · Tel +46 8 506 766 00 · info@mediroyal.se · www.mediroyal.se
Strap 110 mm, NRX Strap PLUS 80 mm, NRX
® ®
2
®
Cut the reinforcement from either normal NRX
depending on preference. Cut a C-shaped reinforcement from the NRX
Strong EU445161 and attach on the NRX
hook tabs over the straps and an anchor over the side.
– One strap, unlimited options!
Hook Strong EU445161
®
Strap or NRX
®
Strap reinforcement. Then attach two
®
Strap Plus,
®
Hook
®