Finishing And Decorating; Filling And Sanding; Pavement; Street Markings/Shoulder And Signs - Faller Car System Manual

Finishing and decorating

Add a final touch to your street before traffic starts moving permanently.
Line the kerbside with guide posts and secure
curves with crash barriers. The kerbside can easi-
ly be created with a little filler and some spread-
ing material. Set up traffic signs and design ad-
Filling and sanding: Create a smooth roadway and fill
any gaps and uneven areas with Filler (180500). The street
sections form a perfect joint for the filling paste. Once cu-
red grind the surface with fine grit sandpaper or a scraper
so the contact wire still shows through in all areas.
Street markings: The outside street boundaries can be
painted on with a white touch-up pen and, depending on
the street route, a straight ruler or curve template. The cen-
tre line is available as a rub-on with the item »Street mar-
kings«. First mark the centre line using a ruler and pencil,
cut strips from the sheet, affix them on the centre line mar-
king using two fingers, and use the included stylus to rub
them onto the street.
ditional, non-functional streets and areas using
various self-adhesive films from our design line.
Create the perfect illusion of mobility.
Pavement: The asphalt can be added quickly and evenly
with the Roadway Paint (180506) and a narrow paint roller
or a brush. Once dried the non-slip surface texture provides
a perfect grip for the tyres on your Car System vehicles.
Shoulder and signs: Use an awl to pierce the required
holes for inserting the guide posts and crash barriers, then
secure the parts with adhesive. The set of traffic signs inclu-
des the matching signs by era. Secure in the same manner
as the safety equipment.
Roadway design 7