Table of Contents
Advertisement
The mains connection must be with a cable with a
plug or there must be a disconnecting device with
at least 3 mm contact opening in the existing do-
mestic electrical installation, which disconnects
the dishwasher completely from the mains supply
in accordance with NIN 2000.
In respect of fire protection, this appliance corres-
ponds to type Y (EN 60 335–2–6). Only this type
of appliance may be installed with a high cupboard
or wall on one side.
It is not permitted to fit drawers below the cooking
surface.
Protection against electric shock must be provided
by the installation.
The kitchen unit in which the appliance is fitted
must satisfy the requirements of DIN 68930 in re-
spect of stability.
Built–in ovens and cooking surfaces are fitted with
special connector systems. They may only be
combined with appliances with a matching system.
All cut surfaces are to be sealed with a suitable
sealant for protection against moisture.
On tiled work surfaces, the joints in the area where
the hob sits on the surface must be completely fil-
led with grout.
On natural, artificial stone, or ceramic tops, the
snap action springs must be bonded in place.
Ensure that the seal is correctly seated in the frame
and that it is seated against the work surface wi-
thout leaving any gaps. Additional silicon sealant
must not be applied, this will make removal more
difficult in the event of the need for service.
59
Advertisement
Table of Contents
