Ourmeter LCD-S900 Manual

Ourmeter LCD-S900 Manual

Ebike intelligent display

Advertisement

Manual
LCD-
-S900 Ebike Intelligent Display

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LCD-S900 and is the answer not in the manual?

Questions and answers

Никита
July 13, 2025

Как переключить режим с eco на другой режим?

Виктор
July 1, 2025

Как включить круиз контроль

User image 686428f7be50f

Subscribe to Our Youtube Channel

Summary of Contents for Ourmeter LCD-S900

  • Page 1 Manual LCD- -S900 Ebike Intelligent Display...
  • Page 2 5) Error code: “ERROR” and code when there is error 6) Assist level: actual assist level 0~5, 0 –no assist, 1- ECO, 2,3-STD, 4,5-POWER) Distance: Trip/ODO 6km mode 2. Press button definition LCD-S900 uses independent press button, in total three buttons:...
  • Page 3 、 “UP”、 “MODE”、 “DOWN” “DOWN”。 3. Operation instructions Power ON/OFF (MODE When the power is off, Long press When the power is off, Long press MODE)during 3 seconds,screen will display all contents and start to normal will display all contents and start to normal will display all contents and start to normal working mode, and controller will be turned on working mode, and controller will be turned on...
  • Page 4 to switch ODO/TRIP , Trip Short press Trip(Single trip distance)→ODO(Accumulated distance) (Accumulated distance) Figure Figure 2 Figure 3 3) Assist level Short press to change assist level level,default value is level 1...
  • Page 5 4) Head light control Head light control ,turn on/off the head light。 Long press 5) 6km mode...
  • Page 6 When the bike is stopped, long press When the bike is stopped, long press , will enter 6km/h mode, the speed will be 4.5~7.5km/h according to 6km/h mode, the speed will be 4.5~7.5km/h according to 6km/h mode, the speed will be 4.5~7.5km/h according to different road condition road conditions, “WALK”...
  • Page 7 : 1) P07-speed limit: short press to set the speed limit from 15 15 to 45Km/h. P11-Reset all parameters Reset all parameters: long press 5 seconds 5 seconds,when it displays “SSSS”,all parameters all parameters reset to default values(except for the ODO distance) reset to default values(except for the ODO distance) 5.
  • Page 8 High Battery Level Motor Hall sensor error UART receive error Table 1...

Table of Contents

Save PDF