Electrical System
Replacing Bulbs
To remove, push the bulb in and turn
to the left, then lift the bulb out.
To install, grip the bulb with a paper
tissue or similar cloth, align the pins
on the base of the bulb with the
grooves in the bulb socket, push in
lightly and turn to the right until the
stop is felt.
Install only bulbs of prescribed
wattage. Refer to " Technical Data and
last page" .
Headlamp Aiming
Correct headlamp aiming is of para
mount importance to the roadworthi
ness of the car. Check and readjust
headlamps at regular intervals and
invariably when a lamp has been
replaced.
Front Lamps
1
Cover. Remove cover (1) after
backing out knurled plastic nuts
located behind headlamps.
2
Sealed-beam unit for high and
low beam
3
Fog lamp
4
Turn signal, parking, side marker
and standing lamp
5
Securing nuts for cover
6
Securing nuts for turn signal,
parking, side marker and stand
ing lamp
7
Vertical aiming screw, sealed-
beam unit
8
Horizontal aiming screw,
sealed-beam unit
9
Vertical aiming screw, fog lamp
10
Horizontal aiming screw, fog
lamp