Wireless Network - Beko B50 A 800 B User Manual

NETWORK SETUP

Wireless network

Wireless network connection
1
Television includes a built-in Wireless WiFi
Adapter to connect it to wireless network.
Notes:
Wireless LAN adapter supports IEEE
7
802.11B/G and N communication
protocols. We recommend you to use
IEEE 802.11N protocol to obtain the best
performance in HD video playback over
wireless connection.
If you use a modem that supports IEEE
7
802.11B/G, video playback performance
may be poor when compared to a modem
that supports IEEE 802.11N since the data
transfer rate of IEEE 802.11B/G protocol
is lower.
It is recommended to switch off the
7
equipment that are not in use in home
network in order to avoid unnecessary
network traffic.
Placing the modem or wireless network
7
sharer on an elevated location will increase
the wireless connection reception strength.
Wireless connection reception strength may
7
vary depending on the type of the modem
and the distance between the modem and
television.
Television / User Manual
-------------------------------------------------------------------------------------------
Connecting automatically by entering
the network password
1
Open the menu with »MENU«.
2 Press »
press »
3 Press »
Network« and press »OK« to confirm.
4
To approve the Privacy Policy, press »
to select »Accept« and press »OK« to confirm.
– »Wi-Fi Network« menu will be displayed.
5 According to your network infrastructure,
press »
»IPv6« and press »OK« to set »On«.
Note:
To access the internet through IPv6, your
7
internet service provider and modem must
support IPv6. If only the modem supports
IPv6, it can only connect to the modem; you
cannot connect to internet.
6
Press »
and press »OK« to confirm.
– Wireless networks will be scanned and
displayed in the »WIFI List« menu.
7
Select the network you want to connect with
»
V
– Wireless connection password screen will
be displayed.
Note:
For device to discover the wireless modem
7
on the network, the network name should
support ASCII characters.
8 Select the required character with »
>
» «, »
character with »OK«.
– Using »A1$« ➡ »OK«, you can switch
between uppercase letters / numbers and
lowercase letters / special characters.
– Select »
and press »OK« to confirm.
9
Press »
network.
– »Connecting ... « message will be displayed
and if the connection is successful, »Connect
Success« message will be displayed.
10
Press »EXIT« to finish the setting.
« or » « to select »Network« and
V Λ
>
« to confirm.
« or » « to select »Wireless
V Λ
« or » « to select »IPv4« or
V Λ
« or » « to select »Base Station«
V Λ
« or » « and press »OK« to confirm.
Λ
« or » « and move to the next
V Λ
« to delete the character entered
« (green) to connect to wireless

< >
« or » «
<
«,
61 / 80 EN