Autonomous Capture - ProfiTap IOTA 10G User Manual

3.3 AUTONOMOUS CAPTURE

To be able to capture traffic in networks where remote access over the network is
not allowed or not possible, you can start IOTA's autonomous capture feature by
pressing the physical START/STOP button.
START: Starts capture. IOTA will use latest settings in Capture Control
STOP: Stop Capture
FACTORY RESET: Disconnect power from IOTA. Long-press the START/STOP
button and while holding, reconnect power and hold for 20 seconds. FACTORY
RESET is complete when LEDs are green.
RESET: Long-press the START/STOP button and hold for 20 seconds. RESET is
complete when LEDs are green. This will reset password and network parameters.
SHUTDOWN: Press and hold for 10 seconds for safe device shutdown. This will stop
capture and unmount the internal disk in order to end capture session.
▶ Note: Make sure the appropriate settings have been applied in 'Interface
Configuration' before deploying the IOTA in the network you want to analyze.
18