Advertisement
28.
LED Green when Sync Voltage is Applied
29.
LED Red when Low Battery
30.
Interface Socket
31.
Battery Compartment
Slave Options
There are 3 possible ways the Hensel Strobe Unit can be slaved to each other:
1. SLAVE button on the back of the head.
Select the SLAVE button on each head that requires slaving.
Keep flash units at least 2 meters apart or the built-in slave may be damaged. Deselect
SLAVE and use a flash sync cable if it is not possible to have the units setup farther
apart.
2. Hensel Strobe Wizard Plus
Insert wizard into camera's flash mount and connect wire into the sync port of the
camera.
Each strobe can be setup for independent control from the wizard using the channel
option located on the side of the wizard. On the strobe head press the Flash Power
Control Switch for channel selection.
Page 10
Advertisement
