Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3.
Page 3
Suggested Method of Installation Mounting Da-Lift Projector Lift between joists. Install the joists at the proper height and width to fit the Da-Lift you are installing. See Figure 1. NOTE: The Da-Lift must be installed on top of the joists. Be sure to leave access from above for installation.
Page 4
Be sure the wires are long enough for the Da-Lift to go up and down. 240 Volt Wiring Diagram Da-Lite offers two styles of 240-volt wall switches for standard operation. Please see wiring diagram included in wall switch box.
Page 5
Da-Lift Projector Lift Adjustment Models 15, 19, 19L Models 10M, 15M Da-Lift projector lift travel is stopped automatically in the full up Use a small screwdriver or 5/32” hex wrench and insert in and full down positions by limit switches, which have been number 2 switch.