Table of Contents
Advertisement
Available languages
Available languages
POSITIONING
Height adjustment
The height of the appliance is adjustable from 820 to
870 mm to fine up with existing kitchen units.
Before installing the appliance between unite, adjust
the height of the feet and rear wheels. The wheels
are factory set for a height of 820 mm. To align the
appliance to a height of 870 mm, raise it by adjusting
the feet with a spanner, then remove the wheels and
refit them in the lowest position.
Fitting the side panels
•
Fit the brackets onto the panels in the positions
shown in the diagram. The dimension of 260* mm
is allowed for fitting a 100 mm plinth below the
panel. For different plinth sizes, increase the
dimension of 260* mm accordingly.
•
Rest the panels against the appliance.
•
Fit the rear brackets, taking into account the
thickness of the panels (maximum width of unit
900 mm).
•
For a correct alignment make sure that the
distance between the appliance and the cabinet
is of 45 mm.
•
Secure the panels at the front.
•
Check the alignment of the doors, loosening the
fixing nuts and screws and by means of the slots.
•
Tighten the clamp screw on the bottom hinges of
the doors.
28
Advertisement
Table of Contents
