Physical Location - Gamry Instruments Faraday Shield Operator's Manual

Physical location

Normally place your Faraday Shield on a flat workbench surface. You need access to the top, rear, left, or right side
of the Faraday Shield for cable connections. There are handles on both side and the rear panel to carry the Faraday
Shield.
If you place your Faraday Shield within an enclosed space, make sure that the internal temperature within that
space does not exceed the 45C ambient temperature limit of the Faraday Shield. Be particularly careful if a
computer or other heat-dissipating equipment is mounted in the same enclosure.
Caution! If the Faraday Shield is taken from a cold location (for example: outdoors in
winter conditions) to a warm, humid location, water vapor could condense on the cold
surfaces inside the Faraday Shield. Allow at least one hour for the Faraday Shield to warm
to room temperature.
Chapter 3: Unpacking and Installation--Physical location
3 - 6