Gamry Instruments Faraday Shield Operator's Manual page 15

2. Insert bottom panel
•
slide bottom panel from the lower end inside the side panel assembly
•
standoffs of bottom panel don't have to be inserted into clearance holes yet
3. Connect door panel sub-assembly
•
connect front panel sub-assembly to one side panel using the quick-release hinges
•
open the door and slightly lift up the front part of the bottom panel with its standoffs
•
align front panel and connect other side using the quick-release hinges
4. Mount bottom panel and feet
•
once the door panel sub-assembly is connected, align all four standoffs of bottom panel with
clearance holes and fully insert
•
lift the cage assembly and screw rubber bumper onto threaded studs
•
verify that the bottom panel if flush mounted
Chapter 3: Unpacking and Installation--Assembly
3 - 3