Vaultek LifePod Series Instruction Manual page 2

STEP ONE: Battery Installation
To get started, undo both side compression latches to open your LifePod™.
Locate the battery cover on the front wall and remove by pressing on the outer tab (Fig A).
Carefully pull out the 9v battery snap inside the battery compartment, and connect an Alkaline
9V battery to the connector. Be sure to snap the battery in the correct orientation (Fig B). A 9v
Alkaline battery is not included.
When the battery is snapped in you will hear a short welcome tone and the keypad will light up.
Once you hear the tone and see the keypad light up, slide the battery into its compartment being
mindful to place the battery ribbon underneath the battery first (Fig C). This will make the battery
easier to remove when replacing.
Replace the battery cover and you are ready to program your LifePod™.
A B C
Quick Setup