Operation; Operator's Controls; Switch On Device - Nouvag NM 3000 Operation Manual

NM 3000

5.1 Operator's controls

Front
Front side:
A) "Overheat"LED:
Illuminates in the case of motor overload.
If the "Overheat" LED illuminates, the device must be switched off for at least
10min.
B) "Power" LED:
Illuminates when the device is switched on
C) "FORWARD / REVERSE" switch:
Adjustment of the direction of rotation: Forwards / Neutral / Backwards
D) "0 ... 35,000 RPM" control knob:
Adjustment of the rotational speed
E) "MOTOR" socket:
Connection of micromotor or motor handpiece
Back:
F) "FOOT" connector:
Connection of foot pedal (optional!)
G) "ON /OFF" switch:
Switching on/off of control device Æ illuminates when control device is switched on
H) "LINE" cable:
Mains supply 115 V~ / 60 Hz or 230 V~ / 50 Hz (see device label!)

5.2 Switch on device

The control device is switched on and off with the "ON /OFF" switch (at the back!) Æ When the device
is switched on, the "ON /OFF" switch and the "Power" LED illuminate.
4

5 Operation

Back
No. 31884 29/05