PAC BCI-CH21 Instruction Manual page 16

BCI-CH21
PAC App
PLEASE NOTE:
The BCI must be programmed with revision 9 or higher to support app programmability. You can program the BCI
either on the bench or in the car (with ignition on).To program the BCI module with the PAC app, follow these steps:
1. Download and install the PAC app.
2.
Once installed, open the app.
3. Connect the interface to the PC.
4. When first connected, the revision info for both the app and the interface should be displayed. Select "Configure". (Fig A).
5.
You may now choose between "Camera Settings" and "Interface User Options" on the left, then make selections within those categories
on the right (Fig B) Plese reference the chart below for all available features and descriptions.
6.
Once all selections have been made, you can simply disconnect the interface and install it.
Feature Option
Double tap turn signal
Turn Signal
Blind Spot Camera
Turn signal and moving above
xMPH
Greater than 0MPH and less
than xMPH
Manual Only
Front Cam
On when shift into D until 6MPH
or 30 seconds
On when shift out of R until 6
MPH or 30 seconds
Accessory
Any Camera Active
Prog Out 1
Reverse Camera Image
Reverse Gear
Accessory
Driver Blind Spot Camera
Forced Reverse Camera Image
Front Camera Active
Prog Out 2 & 3 Passenger Blind Spot Camera
Reverse Camera image
Reverse Gear
Off
Pacific Accessory Corporation
Fig A
Available BCI-CH21 Features
This will activate the camera input when you double tap the turn signal within 2 seconds.
This will activate the camera input whenever a turn signal is on.
This will activate the camera input when a turn signal is active and the vehicle is going faster than the
designated number.
This will activate the camera input whenever the vehicle is going faster than 0 mph or less than the
designated number.
This will allow you to activate the camera input manually by using the on-demand activation toggle
switch.
This will activate the camera input whenever the vehicle is placed into Drive. The camera input will
turn off once the vehicles MPH is faster than 6MPH, or after 30 seconds.
This will activate the camera input whenever the vehicle is shifted out of reverse. The camera input
will turn off once the vehicles MPH is faster than 6MPH, or after 30 seconds.
Interface User Options
This will provide a 12v+ trigger whenever the key is in the accessory or run position.
This will provide a 12v+ trigger whenever any camera is triggered.
This will provide a 12v+ trigger whenever the vehicle is placed in reverse or the reverse camera is
forced on using the SWC or the on-demand activation toggle switch.
This will provide a 12v+ trigger whenever the vehicle is placed in reverse.
This will provide a 12v+ trigger whenever the key is in the accessory or run position.
This will provide a 12v+ trigger whenever the driver side blind spot camera is activated.
This will provide a 12v+ trigger whenever the reverse camera is forced on using the SWC.
This will provide a 12v+ trigger whenever the front camera is activated.
This will provide a 12v+ trigger whenever the passenger side blind spot camera is activated.
This will provide a 12v+ trigger whenever the vehicle is placed in reverse or the reverse camera is
forced on using the SWC.
This will provide a 12v+ trigger whenever the vehicle is placed in reverse.
Reverse Camera Input and Navigation Unlock
Interface for Chrysler / Dodge / Jeep Vehicles
Camera Settings
Description
Fig B
Notes
This mode will not work in vehicles with a manual
transmission.
This mode should only be used in vehicles that have
a manual transmission.
This is the default setting for Prog Out 1.
This is the default setting for Prog Out 2 & 3.