Advertisement
Programming of your new remote control:
There are several methods for programming your new remote control.
From a remote control that has already been programmed:
1. With a sharply pointed object, press the hidden button PRG on your already-programmed
remote control for 2 seconds.
2. Press a button on your new remote control. Let it go.
3. Wait 10 seconds.
4. Your new remote control is programmed.
From the receiver :
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button PRG. The LED light on the
receiver illuminates and blinks. Let the button go.
3. The LED light on the receiver remains lit fixedly. Press a button on your new remote control.
Let it go.
4. Wait 10 seconds.
5. Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
DITEC Bixa G4
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151
Advertisement
Table of Contents
Related Manuals for DITEC Bixa G4
Summary of Contents for DITEC Bixa G4
- Page 1 Programming Manual DITEC Bixa G4 Programming of your new remote control: There are several methods for programming your new remote control. From a remote control that has already been programmed: 1. With a sharply pointed object, press the hidden button PRG on your already-programmed remote control for 2 seconds.
- Page 2 Programming Manual To erase all your remotes control : 1. Press the button PRG of your receiver for 3 seconds. The LED light on the receiver blinks. 2. During the following 5 seconds, press the button PRG again. The LED light blinks faster. 3.
Need help?
Do you have a question about the Bixa G4 and is the answer not in the manual?
Questions and answers