Zanussi ZDT 420 User Manual page 6

Programme selection buttons
Half load button
6
• Starting the washing programme:
1. Press the On/Off button.
2. To select a programme, press either one of the
two programme selection buttons, the indicator
lights of the programme selection buttons start to
flash and the number corresponding to the last
performed washing programme will appear in the
digital display.
Using these two buttons you have an increasing
( ) or a decreasing ( ) order in the selection of the
programme (see "Washing programmes" chart for
the number of the programme).
Example:
– Button (increasing order) : 1→2→3 etc...
– Button ( decreasing order) : 1←7←6 etc...
3. Close the dishwasher's door, the programme will
start automatically.
IMPORTANT!
• Cancel the washing programme in progress:
1. Open the dishwasher door.
2. Press the function buttons 2 and 3
simultaneously for about 2 seconds, the indi-
cator lights of the programme selection buttons
will start flashing. After about 2 seconds the in-
dicator lights of the programme selection but-
tons will illuminate with a fixed light and 2
horizontal lines (- -) will appear in the digital
display.
3. Switch off the machine by pressing the On/Off
button or select a new washing programme
(check that there is detergent in the detergent
dispenser.
The option must be linked to the selection of a washing
programme. (See "Programme table" chart). When
selected, the corresponding light illuminates. Load
dishes in both baskets (lower and upper).
When using the option reduce the dosage of detergent
which is normally used for a complete load.