Advertisement
INSTALLATION NOTES:
3. Product Installation (cont.)
②
Run conduit and/or wiring (code dependent) to the
ideal "knockout(s)" in the construction sleeve.
③
Use a tool of choice to forcefully remove the
knockout.
E0000
➍
REV
ECO
Connect the conduit/wire runs to the sleeve with
couplings of choice (1/2"-14 NPT).
⑤
Attach sleeve cover to protect the interior during
wall finishing using included fasteners.
ARCHITECTURAL & LANDSCAPE LIGHTING
rNook-
AAA
7/22/2012
REVISION DESCRIPTION
DRFT
DATE
|
holmlighting.com
16
⑥
Remove sleeve cover to resume installation.
⑦
DENOTES CRITICAL INSPECTION POINTS
UNLESS OTHERWISE SPECIFIED:
DENOTES FUNCTIONALLY CRITICAL POINTS
Connect wiring from housing assembly to the
SCALE:
DIMENSIONAL
SURFACE FINISH:
TOLERANCES:
REL.
.XX = ±.01
DATE:
incoming power lines using the wiring diagram (see
.XXX = ±.005
DRAWN
THIRD ANGLE PROJ.
.XXXX = ±.0005
BY:
±1°
previous section) and approved wire connectors.
CHECKED
ANGLES:
BY:
DESIGNER:
ALL DIMENSIONS ARE IN INCHES
PRINT
DO NOT SCALE DRAWING
APVD
DATE:
⑧
Insert complete housing assembly into
construction sleeve
⑨
Place the housing inside the sleeve and fasten
screws through center slots on left and right sides.
Before fully tightening, rotate housing according to
level for ideal installation.
CONFIDENTIAL AND PROPRIETARY
THIS DRAWING/DOCUMENT CONTAINS TRADE SECRET INFORMATION OF HUNTER INDUSTRIES, INC. USE, PUBLICATION, AND/OR
DISCLOSURE OF THIS INFORMATION TO THIRD PARTIES ARE ALL PROHIBITED EXCEPT AS EXPRESSLY AUTHORIZED IN ADVANCE BY HUNTER.
NO PATENT LICENSE IS GRANTED TO ANY INVENTIONS DESCRIBED AND/OR ILLUSTRATED HEREIN. ©COPYRIGHT HUNTER INDUSTRIES, INC.
SIZE:
B
1:3
TITLE:
PRODUCT:
DRAWING NO.
MATERIAL:
3/3/2017
Customer Service 1-844-200-4656
4
Hunter Industries
Engineering
1940 Diamond St.
San Marcos, CA 92078
REV.
SHEET 1 OF 1
Advertisement
