Unpacking And Assembly; Unpacking; Assembly - Royal Appliance International Dirt Devil Fello & Friend Bag Operating Manual

2 Unpacking and assembly

2.1 Unpacking

2 Unpacking and assembly

2.2 Assembly

1
2
Fig. 2
1
3
2
Fig. 3
1
Fig. 4
4
2
1
Fig. 5
1. Unpack the appliance and all accessory parts.
2. Check the contents are all there. Information regarding
the scope of delivery ZPage 20, "An overview of your
Fello & Friend Bag".
ATTENTION:
Always transport/send the appliance in its original
packaging so that it does not become damaged. Keep
the packing material for this purpose. Dispose of any
packing material that is no longer required in accordance
with the provisions applicable in your country.
NOTE:
If you should notice damage due to transport, then
contact your dealer immediately.
WARNING:
Only assemble the appliance if the plug has been pulled
out of the socket. The appliance could be switched on by
accident.
1. Push the end of the suction hose (Fig. 2/1) into the
receiver opening (Fig. 2/2) on the cylinder vacuum
cleaner until the lock clicks into place audibly and
noticeably.
4
2. Push the handle (Fig. 3/1) into the upper end of the
telescopic tube (Fig. 3/2).
3. Push the floor nozzle (Fig. 3/3) onto the lower end of the
telescopic tube (Fig. 3/4).
NOTE:
It may be necessary to push a bit harder.
4. Adjust the length of the telescopic tube. To do this,
press the telescopic tube lock (Fig. 4/1) down. Then pull
the telescopic tube by the handle (Fig. 3/1) to the
desired length. To lock it, release the telescopic tube
lock when you let go. You will hear an audible click.
5. Push the accessories mount (Fig. 5/1) onto the handle
(Fig. 5/2). Then push the furniture brush (Fig. 5/3) and
crevice nozzle (Fig. 5/4) on to the holders for these.
NOTE:
If necessary, you can also attach the accessories mount
to the telescopic tube.
3
Your cylinder vacuum cleaner is now ready to use.
25