Table of Contents
Advertisement
ARD-AYCE65B
4
Wiring Instructions
The unit is supplied with a 1.5 meter (60-inch) pigtail, having a
6-conductor cable. To connect the unit to the controller,
perform the following:
Prepare the unit's cable by cutting the cable jacket back 1¼
inches and strip the wire ½ inch. Prepare the controller cable
by cutting the cable jacket back 1¼ inches and strip the wire ½
inch.
Splice the unit's pigtail wires to the corresponding controller
wires and cover each connection.
Refer to the wire color table below, and to the wiring diagram
provided on the following page.
Reader
5~16 VDC
Shield/ Ground
Data 1 / Clock
Data 0 / Data
LEDCTL
Tamper
If the tamper output is used, connect the purple wire to the
correct input on the controller.
Trim and cover all unused conductors.
Bosch Sicherheitssysteme GmbH
Color
Functionality
Red
+DC Input
Black
Ground
White
Communication
Green
Communication
Brown
LED Control / Auxiliary Input
Purple
Tamper
Installation manual
Wiring Instructions | en
| V 1.1 | 2009.08
9
Advertisement
Table of Contents
