Table of Contents
Advertisement
Appendix C
USR-W610 Ethernet & WiFi Adaptor
You can stream seismic data over a Local Area Network (LAN) or over the Internet in real
time to our Live Stream application or to our cloud-based eqServer data management
system. To do this you will need serial-to-Ethernet/WiFi adaptor. This adaptor is simple to
configure and is included in the optional Gecko accessory that provide Power, Alarm &
Communications in wall mountable box.
The "W610" adaptor is manufactured by USR IOT and uses web pages for configuration. The
device allows an RS232 serial port to be routed to a virtual port on a remote computer,
which our data reception software is monitoring for real time connections.
To communicate with the W610 using an Ethernet cable, connect your computer's Ethernet
port into the LAN socket, ensuring your computer is set to be automatically assigned an IP
address (DHCP, not manual IP). Your computer will likely be assigned the IP address
10.10.100.100. Then open a web browser and type
browser. When prompted, log in with username and password admin and admin.
To communicate with the W610 via WiFi, use your phone, tablet or computer to connect to
a WiFi network called USR-W610_XXXX (where XXXX is a variable ID). No password is
required. Once connected, open a web browser and type
your address bar. When prompted, log in with username and password admin and admin.
Quick Configure
If you need to assign the W610 a fixed Ethernet IP address, advanced users are able to
work through the additional network settings in the left sidebar menu. If you are unfamiliar
with these settings, please consult your IT Administrator for advice.
http://10.10.100.254/
http://10.10.100.254/
39
into your web
into
You will be presented
with the web page
shown here after
logging in. The main
configuration change
required is under
Quick Configure item
4F, where you
specify the address
and port number of
the computer to
which you are
sending data.
Advertisement
Table of Contents
