Advertisement
Quick Links
BHM
11/13/19
NTV-DOC351
3950 NW 120
th
Ave, Coral Springs, FL 33065 TEL 561-955-9770 FAX 561-955-9760
www.nav-tv.com
info@nav-tv.com
SYNC3-RVC
NTV-KIT957
Overview
The SYNC3-RVC interfaces a backup camera input (and 1 additional video input) to the factory
media screen in select Ford vehicles equipped with SYNC 3 (8" only) media systems (2016+).
With KIT800, HDMI input is available with this unit.
Kit Content
HD-LINK Optional KIT800
TYPE-C LVDS
Input cable
SYNC3-RVC Interface
LVDS
Output
cable
Power/CAN
Harness
:
Agreement
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
1 |
P a g e
Advertisement
Related Manuals for Nav TV SYNC3-RVC
Summary of Contents for Nav TV SYNC3-RVC
- Page 1 NTV-KIT957 Overview The SYNC3-RVC interfaces a backup camera input (and 1 additional video input) to the factory media screen in select Ford vehicles equipped with SYNC 3 (8” only) media systems (2016+). With KIT800, HDMI input is available with this unit.
- Page 2 11/13/19 NTV-DOC351 Interface Connectors Touch connection (not req) HDMI Cable from HD-LINK Power/CAN OUOUT LVDS INPUT NOT USED LVDS OUTPUT Dip Switches Dip Switch Settings (c onfigure prior to installation) Dip SW: HDMI CVBS Front cam Adding OEM RVC timer OFF SmartLink SEE BELOW DOWN...
- Page 3 OEM LCD. VIDEO OUT VIDEO IN 7. Connect the blue end of the provded cable to port LVDS port on the SYNC3-RVC interface. 8. Connect the reverse camera (if added) and front camera (if applicable) to the proper RCAs (RVC: ‘CAMERA’...
- Page 4 11/13/19 NTV-DOC351 Connection Diagram Agreement End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger entertainment only.
- Page 5 11/13/19 NTV-DOC351 SYNC3-RVC Operation • After all connections are made and dip switches set properly, start the vehicle. Placing the vehicle in reverse will show the connected rear camera, with dynamic guidelines overlaid onto the media screen. • If adding a front camera, this must be activated by setting DIP SWITCH #2 to ON. Forcing this camera on at any time is performed by holding the Voice Recognition (2 sec) button or pressing the phone Hang-Up button on the steering wheel (shown below).
- Page 6 Follow the instructions below when adding the HDMI adapter (HD-LINK: KIT800) to enable HDMI input to the OEM screen: 1. Disconnect the main power plug from the SYNC3-RVC interface. 2. Put dip switch #1 in the DOWN position. 3. Reconnect the main power plug.