Sharp CD-BK280V Operation Manual page 13

„ To mount the surround speakers on the
wall
The design of the surround speakers allows them to be hung on the wall. Be sure to
use the type and size of screw that is shown to the below.
3.2 mm (1/8")
5 mm (3/16")
Min. 22 mm (7/8")
1
Drive one screw through the wall for each speaker.
5 mm (3/16")
Wall mounting screw
Min. 17 mm (11/16")
Wall surface
z Make sure that both the screw and the wall can support a load of 20 kg (45
lbs.).
z Drive the screws, so there is about a 5 mm (3/16") space between the wall
and the head of the screw.
2
Mount the surround speaker on the wall so that the screw head is
inserted into the slot on the surround speaker.
Wall surface
„ TV/monitor connection
If the TV/monitor has a video input, connect it to VIDEO OUT socket on the rear of
the unit.
9 mm (3/8")
Note:
If the TV/monitor does not have a video input, the VIDEO OUT socket on the unit
should be connected to a VCR with a video input, which in turn should be connected
to the TV/monitor through the TV ANTENNA/CABLE input. (Be sure to turn on the
VCR, and set the VCR's input mode to "auxiliary".)
To video
input socket
Video cable
ENGLISH
01/5/28 CD-BK280V(X)E2.fm
CD-BK280V
TV
E-12