Advertisement
Caution: This amplifier is very heavy!
Lift the amplifier out of its packing by
using the two "hand cut-outs" in the
bottom packing near the transformers.
Or you may find it easier to remove the
unit using the following procedure:
1.
With the top packing in place, turn
the box "upside down" with the "flaps"
open.
2.
Lift the cardboard box off.
3.
Remove the bottom packing first.
4.
Turn the unit the right way up and
remove the top packing.
Please be careful not to damage the
small "tape monitor" and "triode"
switches on the front panel
When re-packing ensure the two hand cut-outs are
towards the rear of the amplifier.
If all four feet do not sit level, small adjustments may be
made by adjusting one or more of the screw feet until
the unit sits level.
The feet may be removed if preferred in order to reduce
the height of the amplifier.
(Please keep this information for future use).
Page 9
Advertisement
