Download Print this page

RCA CHU6 Instruction Manual page 3

Six unit multi charger professional two-way radio charger

Advertisement

FOR ANY PRODUCT WHICH DOES NOT COMPLY
WITH THE WARRANTY SPECIFIED, THE SOLE REMEDY
WILL BE REPAIR OR REPLACEMENT. IN NO EVENT
WILL RCA COMMUNICATIONS SYSTEMS BE LIABLE
TO THE BUYER OR ITS CUSTOMERS FOR ANY
DAMAGES, INCLUDING ANY SPECIAL, INCIDENTAL,
INDIRECT OR CONSEQUENTIAL DAMAGES, OR
THE LOSS OF PROFIT, REVENUE OR DATA ARISING
OUT OF THE USE OR THE INABILITY TO USE THE
PRODUCT.
RCA Communications Systems endeavors to achieve
the accuracy and completeness of this manual, but
is not liable for any possible omission and printing
mistakes or provides no warranty of accuracy or
reliability.
All the reproduction and translation of this manual
without authorization is prohibited.
All the above specifications and design are subject
to change without notice due to continuous
development.
No part of this manual may be copied, reproduced,
translated, stored in a retrieval system, distributed,
or transmitted in any form or by any means,
electronic or mechanical, for any purpose without
the expressed, written permission from RCA
Communications Systems.
The end-user is solely responsible for obtaining
any license or other authorizations required by
the Federal Communications Commission (FCC).
For further information visit www.fcc.gov or call
1-888-CALL-FCC (1-888-225-5322).
Communications Systems
www.RCACommunicationsSystems.com
© 2015 RCA Communications Systems. All rights reserved.
Replacing A Charging Pod
The charging pod is made from quality materials and
designed to provide years of service when properly
used. In most cases, the charging pod will only be
replaced when you want to use the charger with a
different battery.
Follow these steps to change the charging pod:
1. Obtain a charging pod made specifically for the
CHU1. Confirm that the charging pod is compatible
with the battery you want to charge.
2. Unplug the power supply from the CHU1.
3. Turn the locking screw on the bottom of the
charging pod counter-clockwise several rotations.
Lift the charging pod from the charging base.
4. Insert the replacement charging pod into the
charging base and secure with the locking screw.
Do not over tighten the screw.
5. Inspect the charging contacts to ensure they are
clean and unobstructed.
6. Connect the power supply to the CHU1. You are
now ready to charge a battery compatible with the
charging pod.
For Sales, Warranty and Customer Support please contact:
Discount Two-Way Radio Corporation – North American Distributor
1430 240th Street
Harbor City, CA 90710
Phone: 310-224-5100 / Fax: 310-224-5101
www.DiscountTwo-WayRadio.com

Advertisement

loading