LG LWC3063 Series Owner's Manual page 63

Symptoms
Oven will not Self
Clean
"Crackling" or
"popping" sound
Fan noise
Convection Fan stops
Displayed Time is
flashing
Excessive smoking
during a Self Clean
cycle
Oven door does not
open after a Self
Clean cycle
The oven does not
clean after a Self
Clean cycle
CLEAN and door flash
in the display
LOCKED is on in the
display when you
want to cook
Burning or oily odor
emitting from the vent
Oven racks are
difficult to slide
• The oven temperature is too high to set a Self Clean operation.
- Allow the oven to cool and reset the controls.
• Oven controls improperly set.
- See the Self Clean section.
• A Self Clean cycle cannot be started if the oven lockout feature is active.
• Make sure to slide the tank into the slot until it clicks into place.
• This is the sound of the metal heating and cooling during both the cooking and
Self Clean functions.
- This is normal.
• A convection fan may automatically turn on and off.
- This is normal.
• Convection fan stops during a convection bake cycle.
- This is normal and is done to allow for more even heating during the cycle.
This is not a failure of the oven and should be considered normal operation.
• This is normal. This means that the product has just been plugged in, or that it
has experienced a power interruption. Touch the Clock key and reset the time,
or touch any key to stop the flashing.
• Excessive soil.
- Touch the Clear/Off button. Open the windows to rid the room of smoke. Wait
until the Self Clean mode is cancelled. Wipe up the excess soil and reset the
clean.
• Oven is too hot.
- Allow the oven to cool below locking temperature.
• Allow about one hour for the oven to cool after the completion of a Self Clean
cycle. The door can be opened when the lock
• The control and door may be locked.
• Oven controls not properly set.
- See the Self Clean section.
• Oven was heavily soiled.
- Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens
may need to Self Clean again or for a longer period of time.
• The Self Clean cycle has been selected, but the door is not closed.
- Close the oven door.
• The oven door is locked because the temperature inside the oven has not
dropped below the locking temperature.
- Touch the Clear/Off button. Allow the oven to cool.
• This is normal in a new oven and will disappear in time.
- To speed the process, set a Self Clean cycle for a minimum of 3 hours. See
the Self Clean section.
• The shiny, silver-colored racks were cleaned in a Self Clean cycle.
- Apply a small amount of vegetable oil to a paper towel and wipe the edges of
the oven racks with the paper towel.
Possible Causes / Solutions
TROUBLESHOOTING
is no longer displayed.
63