The Control Panel; Programme Chart; Door Release Button; No Buzzer Button - Zanussi TCE 7276 W Instruction Booklet

The Control Panel

CON NSER DRYER

1 Programme Chart

This will help you to select the correct programme
for drying.

2 DOOR RELEASE Button

Press this button to open the door. The light above
the button will light up.
Opening the door by means of this button is
possible only if the tumble dryer is on
(programme selector dial set to a programme or
drying time).
If you open the door during a programme, in order to
restart the programme you must press the
START/PAUSE button again after having closed the
door.

3 No BUZZER Button

A buzzer sounds
• when selecting the programme
• when depressing the buttons
• when an incorrect option selection is made
• when the programme selector dial is turned to
another position during the programme or when
you depress an option button during the cycle
• during the anti-creasing phase
• at the end of the programme
• when the water reservoir is full
• if the machine is not working correctly
• when the small door at the bottom is open.
By depressing the button the acoustic signal is
switched off.
The corresponding light comes on.
6

4 QUICK DRY Button

By depressing this button the drying time is reduced
in the following COTTON programmes:
•
EXTRA DRY
•
READY TO WEAR
•
STORE DRY
The corresponding pilot light comes on.
This option cannot be selected with LOW
TEMPERATURE function.
5 LOW TEMPERATURE
Button
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on.
This option can also be used for time controlled
drying.
This option cannot be selected with QUICK DRY.

6 DELAY START button

This button allows you to delay the starting of the
programme by 12 hours max.
This option must be selected after having selected
the programme and before pressing START/PAUSE
to start the programme.
Every time the button is pressed, the time is
increased by 30 minutes, until the display shows a
delay of "2 hours". After this, the delay is displayed
hour by hour.
The minutes or hours of delay that have been
selected are displayed for 2 seconds, then the display
shows the duration of the previously selected
programme.
The countdown begins after you have pressed the
START/PAUSE button.
5