Where Do I Go From Here; Technical Support - Digi Rabbit Smartcat BL2100 Series User Manual

If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the Serial Options
menu. Choose a lower debug baud rate.

2.5 Where Do I Go From Here?

If the sample program ran fine, you are now ready to go on to other sample programs and to
develop your own applications. The source code for the sample programs is provided to allow
you to modify them for your own use. The BL2100 User's Manual also provi des complete
hardware reference information and describes the software function calls for the BL2100 and
the optional LCD/keypad module.
For advanced development topics, refer to the Dynamic C User's Manual and the
Dynamic C TCP/IP User's Manual, also in the online documentation set.

2.5.1 Technical Support

NOTE: If you purchased your BL2100 through a distributor or Rabbit partner, contact the
distributor or partner first for technical support.
If there are any problems at this point:
• Use the Dynamic C Help menu to get further assistance with Dynamic C.
• Check the Rabbit Technical Bulletin Board and forums at
and at www.rabbit.com/forums/.
• Use the Technical Support e-mail form at www.rabbit.com/support/.
If the sample program ran fine, you are now ready to go on to explore other BL2100 fea-
tures and develop your own applications.
Chapter 3, "Subsystems," provides a description of the BL2100's features, Chapter 4,
"Software," describes the Dynamic C software libraries and introduces some sample pro-
grams, and Chapter 5, "Using the TCP/IP Features," explains the TCP/IP features.
16
dialog in the Dynamic C Options > Communications
www.rabbit.com/support/bb/
Smartcat (BL2100)