Cleaning And Maintenance - Klarstein 52030134 Manual

Noise Inside the Unit
You may notice that your unit makes some unusual noises. Most of these are perfectly normal, but you
should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It has become more
pronounced since the introduction of CFC free gases. This is not a fault and will not affect the performance of
your unit. This is the compressor motor working, as it pumps the refrigerant around the system.
Tips for keeping food in the unit
• Cooked meats/fishes should always be stored on a shelf above raw meats/fishes to avoid bacterial trans-
fer. Keep raw meats/fishes in a container which is large enough to collect juices and cover it properly. Place
the container on the lowest shelf.
• Leave space around your food, to allow air to circulate inside the unit. Ensure all parts of the unit are kept
cool.
• To prevent transfer of favours and drying out, pack or cover the food separately. Fruit and vegetables do
not need to be wrapped.
• Always let pre-cooked food cool down before you put in the unit. This will help to maintain the internal
temperature of the unit.
• To prevent cold air escaping from the unit, try to limit the number of times you open the door. We recom-
mend that you only open the door when you need to put food in or take food out.
Defrosting
Auto-defrost for frost-free refrigerator
Cleaning
• Pull the power plug.
• Take out the food and keep it in a cool place.
• Remove all the shelves and the salad bin. To remove the salad bin first remove the lower door shelf.
• Wipe the inside of the unit with a weak solution of bicarbonate soda and then rinse with warm water using
a"wrung-out" sponge or cloth. Wipe completely dry before replacing the shelves and salad bin.
• Use a damp cloth to clean the exterior, and then wipe with a standard furniture polish. Make sure that the
door is closed to avoid the polish getting on the magnetic door seal or inside the unit.
• The grille of the condenser at the back of the unit and the adjacent components can be vacuumed using
a soft brush attachment.
Maintenance
Changing the internal light: Lamp replacement by professionals.

Cleaning and Maintenance

22