Siemens WM10E262GR Series Operating Instructions Manual page 2

Table of Contents

Advertisement

Safety instructions
Care
– Read the instruction manual and installation instructions and all other information enclosed with the washing
machine and act accordingly.
– Retain the documents for subsequent use.
Risk of electric shock
– Never pull the cable to disconnect the mains plug.
– Never insert/disconnect the mains plug with damp hands.
Danger to life
For worn-out appliances:
– Disconnect the mains plug.
– Sever the mains cable and discard along with the plug.
– Destroy the lock on the washing machine door. This will prevent children from
locking themselves in and risking their lives.
Danger of suffocation
– Keep packaging, film and packaging parts out of the reach of children.
Risk of poisoning
– Keep detergents and care products out of the reach of children.
Risk of explosion
– Items of laundry pretreated with cleaning agents containing solvents, e.g. stain
remover/cleaning solvent may cause an explosion after being loaded into the
washing machine.
Rinse items of laundry thoroughly by hand beforehand.
1. Pull the drawer out, press down the insert and fully remove the drawer
Risk of injury
– The washing machine door can become very hot.
2. To remove the insert: press the insert upwards from below with your
– Be careful when draining hot detergent solution.
– Do not climb onto the washing machine.
3. Clean the detergent dispenser tray and insert with water and a brush and
– Do not lean on the open washing machine door.
– Do not reach into the drum if it is still rotating.
– Be careful when opening the detergent drawer while the machine is in operation.
4. Attach the insert and engage (connect the cylinder to the guide pin).
5. Push in the detergent drawer.
Consumption values
depending on model
Programme
Programme
Load
Electricity**
Water**
duration**
(Cottons) 20 °C
7 kg
0,31 kWh
72 l
2 ¾ h
(Cottons) 40 °C
7 kg
0,85 kWh
72 l
2 ¾ h
(Cottons) 60 °C
7 kg
1,21 kWh
72 l
2 ¾ h
(Cottons) 90 °C
7 kg
2,01 kWh
77 l
3 h
(Easy-care) 40 °C
3 kg
0,64 kWh
56 l
1 ¾ h
(Mix) 40 °C
3 kg
0,46 kWh
36 l
1 ¼ h
Information on the display panel
(Delicate/Silk) 30 °C
2 kg
0,24 kWh
37 l
¾ h
/
(Wool) 30 °C
2 kg
0,22 kWh
47 l
¾ h
E3
E5
Annual energy
Annual water
E6
Programme
Load
consumption
consumption
(Cottons)
ecoPerfect 40/60 °C*
3,5/7 kg
165 kWh
10686 l
E2
* Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water (15 ºC).
** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient tem-
perature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional
functions.
8
8
7
– Risk of electric shock.
Maintenance
Disconnect the mains plug.
– Risk of explosion. No solvents.
Before washing for the first time
Detergent solution pump
Do not load any laundry into the machine. Turn on the tap.
Turn the programme selector to Off and disconnect the mains plug.
Add the following to compartment II:
1. Open and remove the service flap.
– approx. 1 litre water
– detergent (dosage according to the manufacturer's instructions for light soiling and the
appropriate degree of water hardness)
Set the programme selector to
(Easy-care) 60 °C and select
/
2. For models with a drainage hose: Remove the drainage hose from the
(Start/Pause). At the end of the programme, turn the programme selector to Off.
retainer and pull it from the housing. Remove the container.
Machine housing, control panel
Remove the sealing cap, allow the detergent solution to flow out.
Replace the sealing cap and place the drainage hose in the retainer.
– Wipe with a soft, damp cloth.
– Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).
2* For models without a drainage hose: Carefully unscrew the pump cover
– Remove detergent and cleaning agent residue immediately.
until the detergent solution begins to flow out. When the service flap is
– Do not clean with a jet of water.
half full, close the pump cover and empty the service flap. Repeat the
above steps until all the detergent solution has completely drained out.
Cleaning the detergent drawer and housing...
... if it contains detergent or fabric softener residues.
3. Carefully unscrew the pump cover (residual water).
4. Clean the interior, pump cover thread and pump housing (the impeller in
the detergent solution pump must rotate).
from the housing.
5. Replace the pump cover and screw it tightly.
finger.
6. Place the service flap back on and close.
dry it. Also remove any detergent or fabric softener residues in the
housing.
To prevent unused detergent from flowing straight into the drain during the next wash:
Pour 1 litre of water into compartment II and start the
Leave the detergent drawer open so that any residual water can
Drainage hose at the siphon
evaporate.
Turn the programme selector to Off and disconnect the mains plug.
Washing drum and rubber seal
1. Loosen the hose clamp, carefully remove the drainage hose
(residual water).
Wipe the inside of the rubber seal dry with a cloth. Leave the washing machine door open so
2. Clean the drainage hose and siphon connecting piece.
that the drum can dry out. Rust stains - use chlorine-free cleaning agent, not steel wool.
3. Reattach the drainage hose and secure the connection with the hose
Descaling
Ensure there is no laundry in the machine
clamp.
Descale the appliance according to the descaler manufacturer's instructions. This should not
Filter in the water supply
be necessary if the correct dosage of detergent is used.
Risk of electric shock
Do not immerse the AquaStop safety device in water (contains an electric valve).
depending on model
Reduce the water pressure in the supply hose:
Close the washing machine door properly; laundry may be caught.
1. Turn off the tap.
2. Select any programme (except
Open the tap completely, supply hose kinked or trapped;
Clean the filter
page 10, Water pressure too low.
3. Select
Detergent solution pump blocked; Clean the detergent solution pump
page 10.
approximately 40 seconds.
Drainage hose/waste pipe blocked; Clean the drainage hose at the siphon
page 10.
4. Turn the programme selector to Off. Disconnect the mains plug.
Motor fault. Call the after-sales service.
Clean the filter:
1. Depending on model:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or for Standard and AquaStop models:
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
2. Connect the hose and check for leaks.
9
– Risk of scalding. Allow the
What to do if ...
detergent solution to cool down.
– Turn off the tap.
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Wait approx. 2 minutes.
cannot be opened.
– - - - - (without final spin) selected?
Programme does not start.
– Washing machine door closed?
– Childproof lock active? Deactivate
Detergent solution is not
– - - - - (without final spin) selected?
drained.
– Clean the detergent solution pump
– Clean the waste pipe and/or drainage hose.
Water not visible in the drum. – Not a fault - water below the visible area.
Unsatisfactory spin result.
– Not a fault - the unbalanced-load detection system has cancelled the spin cycle
Laundry wet/too damp.
because of uneven distribution of the laundry. Distribute small and large items of
laundry evenly inside the drum.
– Programme
– Speed selected too low?
The programme duration
– Not a fault – the programme sequence is optimised for the particular wash process.
changes during the wash
This may result in changes to the programme duration in the display field.
cycle.
(Empty) programme.
Spin cycle performed several
– Not a fault - unbalanced load detection system adjusts the imbalance.
times.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary
products.
Odour formation in the
– Run programme
washing machine.
detergent.
(Wash) display lamp
– Too much detergent used? Mix 1 tablespoon of fabric softener with ½ litre of water
flashes. Foam may
and pour into dispenser II (not for outdoor and down-filled textiles!).
be coming out of the
– Reduce the detergent dosage for the next wash cycle.
detergent drawer.
Intense noise formation,
– Are the appliance feet fixed? Secure the appliance feet
vibrations and "wandering"
– Transportation safety devices removed? Remove the transportation safety devices
during the spin cycle.
Noises during spin and drain
– Clean detergent-solution pump
cycles.
/
(Rinse/Spin) //
(Empty)).
Display panel/indicator
– Power cut?
/
(Start/Pause). Let the programme run for
lamps do not function during
– Fuses triggered? Reset/change the fuses.
operation.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence longer
– Not a fault - unbalanced load detection system adjusts imbalance by repeatedly
than usual.
distributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse cycle.
Detergent residues on the
– Occasionally, phosphate-free detergents contain water-insoluble residues.
laundry.
– Select
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service
10
/
(Start/Pause) not selected?
page 10.
page 3, 4.
/
(Start/Pause) or
(Finished in) selected?
page 5.
page 3, 4.
page 10.
(Anti-crease) selected?
page 7.
page 5.
page 9.
(Cottons) 90 °C without laundry. Use standard
Washing machine
Installation instructions.
WM10E262GR ...
Installation instructions.
page 10.
siemens-home.com/welcome
en Washing machine
operating instructions
Observe the safety instructions on page 8.
/
(Rinse/Spin) or brush the laundry after washing.
Installation instructions.
Read these instructions and the separate installation
instructions before operating the washing machine.
11
Register
your
product
online

Advertisement

Table of Contents
loading

Table of Contents