Connecting The Display Module To The Host; Connection Options - 4D systems gen4-FTDI Series Getting Started Manual

CONNECTING THE DISPLAY MODULE
This section shows the complete instructions for connecting the display to
the host controller.
Hardware
Display Module

Connection Options

1. Connect one end of the FFC to your module's 30-way ZIF socket with
the metal contacts on the FFC facing up on the latch.
2. Connect the other end of the FFC to the 30-way ZIF socket on the
gen4-Breakout board with the metal contacts on the FFC facing up on
the latch.
3. Connect the pins of the gen4-Breakout to the pins of the Host
Controller.
1
FFC Cable
Adaptor
1
TO THE HOST
gen4-Breakout
Host Controller
Adaptor
2
1
gen4-FTDI Display Series - GETTING STARTED MANUAL
Cable
(FFC)
3
1
Software
Any Software which
can drive your host
controller
|
5