Hook Wizard Preliminary Manual page 8

USB
Use the USB connector to connect to a Mac or PC and run the Ampir software.
Connect the USB cable after you turned the amp "ON"
If USB is connected to the wizard and the editor is running, the cab knob is not functional.
Editor
The amp must be "ON" before connecting the USB cable to your Wizard amp.
Otherwise you get in firmware update mode.
•
Connect the USB cable
•
Start the application on your PC/Mac
1 Directory of your computer, navigate with the "open" button or the "step back" button
2 List of the 16 slots for IR's on your Wizard amp
3 Frequency response chart of the IR's in box 1 (you can also switch to time graph)
4 Select a slot you want to write your new IR to, press "ad as current"
5 The IR you select will fill the first empty slot of your Wizard amp if you press "add as
new"
6 If you are ready with editing press "write to device" only then the changes are made
on the wizard.
7 If you want to make a backup of your 16 IR's press "make backup" A .rib file is written
to the directory you select.
8 If you want to restore from the backup file you created, press "restore from backup"
then press "write to device" to finalize your restore.
9 If you want to update the firmware of your Wizard amp, make sure the power is your
amp turned off. Connect your USB cable to your computer and press button "update
firmware" Select the firmware file. Disconnect the USB cable when prompted.
If you changed anything and want to keep it, press the "write to device" button to confirm
and write it to the flash memory of the speaker sim of the wizard.
Slot 16.