Mason Aluminum Framed Panel Mount Swing Up Rest Benches Installation Instructions

Measure out from the back wall of the run a distance of 1'-8 3/8" and make a mark on the

Division Panel (or side wall). Then measure up vertically a height of 1 3/4" plus the height of

the rest bench (example: If you have a 6-3/4" high rest bench you would measure up 8-1/2").

Make a mark on the panel or side wall. Using a level, transfer the last mark you made to the

rear of the division panel. Do this on both sides of the run. See Figure 1.

Trench Drain

Hold a support bracket so that the rear edge of the bracket is 1 7/16" from the back of the run.

(Note: on back to back runs the bracket will be against the edge of the aluminum that frames

the back edge of the division panel) Hold the top of the bracket even with the mark. Mark the

wall for drilling through both holes in the bracket. See Figure 2.

1−7/16"

Back

Panel

Mark through

both holes

Figure 1.

Page 1 of 4

Installation Instructions for

Aluminum Framed Panel Mount

Swing Up Rest Benches

1'-8 3/8"

1−7/16"

Figure 2.

Level Line

1 3/4" + Restbench

Height

Building

Wall

orm # 50 Rev. F

Table of Contents

Need help?

Do you have a question about the Aluminum Framed Panel Mount Swing Up Rest Benches and is the answer not in the manual?

Page 1 Installation Instructions for Aluminum Framed Panel Mount Swing Up Rest Benches Measure out from the back wall of the run a distance of 1’-8 3/8” and make a mark on the Division Panel (or side wall). Then measure up vertically a height of 1 3/4” plus the height of the rest bench (example: If you have a 6-3/4”...
Page 2 Using a 1/4” drill bit, drill two 1/4” diameter holes through the division panel on the marks made in Step 2. Repeat steps 2 and 3 on the opposite side of the run. Attach the brackets to the Division Panels using 1/4”-20 x 1 1/8” bolts, 1/4”-20 Nyloc nuts, and (for end runs) 1/4”...
Page 3 Insert two 1/2”-13 x 1-1/2” bolts supplied into the threaded plugs as shown in Figure 6. 1/2”-13 stainless steel hex head bolt Figure 6. Leave the bolts extending out of the plug approximately 9/16” as shown. Do not tighten them with a wrench, hand tighten only! See Figure 7.
Page 4 Place the rest bench into positions by situating the bolts into the slot in the front of the restbench brackets and pushing toward the back of the slot until you feel the bolts drop into the bottom of the slot as shown on Figure 8. Figure 8.