Table of Contents
Advertisement
Quick Links
1.
Measure out from the back wall of the run a distance of 1'-8 3/8" and make a mark on the
division panel (or side wall). Then measure up vertically a height of 3 3/4" plus the height of
the rest bench (example: If you have a 6 3/4" high rest bench you would measure up 10 1/2").
Make a mark on the panel (wall). Using a level, transfer the last mark you made to the back
wall of the run. Do this on both sides of the run. See Figure 1.
Back wall of
the run
2.
Hold a support bracket against the back and sidewalls of the run so that the top of the bracket is
even with the mark. Mark the wall for drilling through both holes in the bracket. See Figure 1.
3.
Using a 3/8" masonry bit drill two 3/8" holes in the wall to a depth of 1 1/2".
4.
Repeat steps 2 and 3 on the opposite side of the run.
5.
Insert a 1/4"-20 x 1 1/4" bolt (supplied) through the mounting holes in the support brackets.
Install an anchor plug on each bolt. The end of the anchor should be approximately even with
the end of the anchor. Be sure that the anchor plugs are installed in the correct orientation. See
Figure 2.
Installation Instructions for
Aluminum Framed Wall Mount
Swing Up Rest Benches
1'-8 3/8"
Trench Drain
Figure 1.
Page 1 of 3
Mark through
both holes
Level Line
3 3/4" + Restbench
Height
Form # 45 Rev. E
Advertisement
Table of Contents
Related Manuals for Mason Aluminum Framed Wall Mount Swing Up Rest Benches
Summary of Contents for Mason Aluminum Framed Wall Mount Swing Up Rest Benches
- Page 1 Installation Instructions for Aluminum Framed Wall Mount Swing Up Rest Benches Measure out from the back wall of the run a distance of 1’-8 3/8” and make a mark on the division panel (or side wall). Then measure up vertically a height of 3 3/4” plus the height of the rest bench (example: If you have a 6 3/4”...
- Page 2 1/4”-20 x 1 1/4” stainless steel Anchor plug hex head bolt Figure 2. Attach the grid front support to the angle on the bottom of the rest bench using the supplied hardware. See Figure 3. 1/4”-20 Nyloc Nut 1/4”-20 x 1” stainless steel 1/4”...
- Page 3 Leave the bolts extending out of the plug approximately 9/16” as shown. Do not tighten them with a wrench, hand tighten only! See Figure 5. 9/16" Figure 5. Place the rest bench into positions by situating the bolts into the slot in the front of the rest bench brackets and pushing toward the back of the slot until you feel the bolts drop into the bottom of the slot as shown on Figure 6.
Need help?
Do you have a question about the Aluminum Framed Wall Mount Swing Up Rest Benches and is the answer not in the manual?
Questions and answers