Advertisement
Table of Contents
Record of Normal Condition:
Before using the table for the first time, create a written record of its appearance and functions. Include detailed
descriptions about the frame, casters, load deck, and the mast. Include observations about how the load deck
responds when a test weight is applied to it as well as any sounds you hear. Thoroughly photograph the unit and all
labels. Add the photographs to the record. This record establishes "normal condition". When conducting future
inspections, compare your observations with the record to determine if a component is in normal condition or requires
repair or replacement.
Inspections & Maintenance:
Regular inspections and maintenance are necessary to keep the table in normal condition for as long as possible.
Do not use the table unless it is in normal operating condition. Complete all replacements and repairs before
returning the table to service.
Step 1: Tag the table "Out of Service."
Step 2: At least once per month, inspect the elements listed below. Refer to the appropriate Exploded View on
A. Frame: Inspect all welds for cracks. Inspect the metal tubing for damage, warps, and cracks. Also examine
the connection points between the frame and the formed base piece. Make sure that the nuts and bolts are
securely fastened together and that the bolt holes in the frame are not elongated, warped, or cracked.
B. Casters, caster receivers, and retaining hardware: Check casters for excessive wear. All 4 casters should
solidly contact the ground and should roll smoothly without wobbling. E x a m i n e t h e center hub of each
caster for cracks. Confirm that caster receivers (see
C. Mast (body), load deck, and carriage: Inspect all parts of the deck and carriage for cracks, bends, and other
damage. The deck should be level, square, and rigid. Apply a test load to the deck. Make sure that the deck
descends smoothly and evenly from side to side. If the deck makes a lot of noise as it moves, apply a silicon
wax to the mast track and lubricate the roller bearings.
D. Springs: Remove the top cover and examine the springs. Confirm that every spring is intact. Apply a
test load to the deck and slowly reduce it. Confirm that the springs recoil normally. Replace a spring
if it is stretched, bent, or severely rusted.
Step 3: Complete all necessary repairs/replacements. Deformities, severe corrosion or rusting, or excessive wear of
any part warrants immediate replacement of that part. DO NOT return the table to service until adjustments and
repairs are complete!
NOTE:
Adjustments and repairs differ significantly from modifications.
a) Adjustment (or repair) means a simple correction that restores the cart to normal condition. Examples include
tightening loose fasteners and lubricating moving parts.
b) Modifications are changes that alter the cart from original condition, like bending the frame. NEVER modify the
cart without express, written approval from Vestil. Modifications automatically void the limited warranty and might
make the device unsafe to use.
Step 4: Make a dated record of all repairs, adjustments and replacements.
Step 5: Store the cart indoors in a dry location.
Labeling Diagram:
Each unit should be labeled as shown in the diagram. However, label content and location are subject to
change so your product might not be labeled exactly as shown. Replace all labels that are damaged, missing, or
not easily readable (e.g. faded). To order replacement labels, contact the technical service and parts department
online at http://www.vestilmfg.com/parts_info.htm. Alternatively, you may request replacement parts and/or service
by calling (260) 665-7586 and asking the operator to connect you to the Parts Department.
A
B
C
Table of Contents
Rev. 10/9/2018
p. 3
or 4) and retaining hardware are in normal condition.
A: Label 287
B: Label 658
C: Label 212
Copyright 2017 Vestil Manufacturing Corp.
ETS MANUAL
p. 3
or 4.
Page 6 of 7
Advertisement
