Berghoff Tronic Series Manual page 28

4. To select temperature setting, press the" TEMP" button once (defaults=120°C), the tem-
perature light will turn a steady red, and press the REDUCE or INCREASE until the correct
temperature setting is achieved.
5. To select automatic timer setting, press the" TIMER" button twice (defaults =0mins), the
timer light will turn a steady red, and press the REDUCE or INCREASE button until the correct
timer setting is achieved. You will be able to select the operating time in increasing 5 minutes,
and reducing 1 minute. (The timer is between 0 to 150 minutes)
6. After the cooking is completed, press the ON/OFF button again to turn off the unit.
7. When the unit has been used excess 150mins, it will show "EE" as error code from the LED
window. the unit will automatically stop, to press ON/OFF button to restart the unit.

!
NOTE: The power will completely shut off within 9 second if either (a) the wrong type of cook-
ware is applied or (b) no cookware is placed on the unit.
USABLE AND NON-USABLE UTENSILS:
Compatible Pans: Steel or cast iron, enameled iron or 18/10 stainless steel, all with

flat-bottoms and a with a diameter of 12 to 26 cm.
Non- compatible Pans: Heat-resistant glass, ceramic container, copper, aluminum

pan/pots. Rounded-bottom pan/pots with the base measuring less than 12 cm.
HOW TO CLEAN:
Clean after each use. Disconnect plug and wait until the unit has cooled down.

If the pots/pans that are used are not clean, staining or dis-colorization may occur.

Do not use benzene, thinner, a scrubbing brush or polishing powder to clean the

induction cooker.
Wipe down the unit using a dish washing agent and a damp cloth.

Use a vacuum cleaner to suck up dirt from the air intake and exhaust vent.

Never run water over the unit (If water gets inside it may cause malfunction).


!
WARNING: Any other servicing should be performed by an authorized service representative.
- 28 -