Safety Advice - Berghoff Tronic Series Manual

change the settings at any time, ranging from 1-10. LED-display "POWER" appears.
• "Temp" (2x pressing the "Function" button)
The pre-set temperature stage "120°C" is selected and the device turns on. With the arrow keys,
you can change the settings at any time, ranging from
appears.
• "Timer" (3x pressing the "Function" button)
After having selected the operating mode (power stage or temperature stage), press the "Timer"
key. The number "0" appears on the display and the LED-display "TIMER (min)" next to the
display appears. By using the arrow keys, you will be able to increase the time in intervals of 5
minutes, up to 150 minutes maximum. You can alse decrease the time and this in intervals of 1
minute. Once the time is up, you will hear an acoustic signal and the device automatically enters
standby mode.
Just as well, you may adjust the power stage or temperature stage selection without a
change of time specification.
Once the cooking or warming process is finished, disconnect the main plug from the

outlet!
Do not place any empty cookware on the glass top. Heating an empty pot or pan

activates the overheating protection and the device turns off but this could occur
after your cookware has been damaged.
Do not operate the device if it is damaged in any way or if it does not function

properly.
The use of accessories and spare parts not recommended by the manufacturer may

lead to damage on the device and may cause injuries.
7. Cleaning and safety procedures
7A. Safety advice
Before moving or cleaning, make sure the appliance has been disconnected from the

power socket (pull the power plug!!!) and has completely cooled down.
Do not use any acidic agents and make sure no water enters the appliance.

To protect yourself from electric shock, never immerse the appliance, its cables or

the plug in water or other liquids.
Only use a soft cloth and make sure you never use any kind of abrasive agents or

pads, which could scratch the surface.
Regular dish liquid and water are sufficient to remove marks of finger prints, grease

. LED-display "TEMP (°C)"
60°C - 200°C
- 18 -