Daewoo WFW0A1 Series Service Manual page 30

5. Error Display
MESSAGE ERROR
WATER INLET
IE
ERROR
OE
ERROR
UN-BALANCE
UE
ERROR
DOOR OPEN
LE
ERROR
Water level
E1
detection error
OVER FLOW
E2
ERROR
FAN MOTOR
E3
ERROR
SENSOR
E9 PRESSURE
ERROR
WFW0A1*,WFW0A2*,WFC0A2*(SM).indd 29
CAUSE
Fail to reach specifying the level
of the water for 30 minutes on
supply water.
Not change the level of water
on supply water.
DRAIN After 10 min on supply water.
not reach reset point.
After balance spin 40 times.
don't operate main spin
If balance spin is fail, don't
operate the rinse.
So don't display 'UE'
The Start/Hold button is
pressed while the door is
opened.
Water level is below reset or
overflow is detected
The water is supplied
continuously. Then it happens 2
times to over the level of
overflow.
don't receive the HALL IC
signal from the fan motor.
The water level sensor is
abnomal on less 19KHz , more
28KHz.
- Open the water tap.
- Clean the filter of the valve inlet.
- Change the valve inlet.
- Change the PCB ASS'Y.
- Change the drain motor.
- Change the water level sensor
(sensor pressure).
- Clean and straighten the drain hose.
- Change the drain motor.
- Change the valve inlet
- Change the PCB ASS'Y.
- Change the water level sensor.
- Rearrange the laundry.
- Rearrange the laundry.
- Close the door.
- Change the switch door lock.
Change the sensor pressure.
- Change the valve inlet.
- Change the water level sensor
(sensor pressure).
- Change the drain motor.
- Change the fan motor.
- Check the connector or change the
PCB ASS'Y .
- Change the water level sensor.
29
SOLUTION
16. 5. 24. 오후 3:20