Compressed Air Fittings - Clayton Barracuda Electric Safety, Operation & Maintenance

Immersion separator 120v / 220v with pneumatic tool sync

Hide thumbs

Table Of Contents

Table of Contents

WARNING

1. Power Head Vents

• NEVER BLOCK THE POWER HEAD VENTS

• NEVER WRAP THE POWER CORD AROUND THE POWER HEAD VENTS

2. Remove and identify the Vacuum,

Included in the Box.

3. If Needed Install the Power Head

• Install the HEPA filter on the power head by threading the filter onto the threaded adapter until snug

• Place the power head on top of the vacuum tank

• Secure the head in place with the tank draw latches

4. Activate the HEPA Filter Timer

• The HEPA Timer Card is attached to the Power Head

• Follow the directions on Timer Card to activate

5. Fill the Tank with Water

• Ensure that the gate valve in the lower compartment is closed by pushing the valve plunger handle in

• Connect a garden hose to the water inlet directly above the vacuum inlet

• Turn the water on

• Open the ball valve on the water inlet to begin filling

• Close the ball valve and disconnect the hose when the water level reaches the Fill Line on the Barracuda sight window

6. Water Level Sensor

• Ensure That the Water Level Sensor Cable is Connected from the Tank to the Power Head

7. Power Switch

• Set the Power Switch to the Off Position

The vacuum has the following Compressed Air Requirements to function properly.

• Compressed air must be clean, dry, and oil free to prevent blockage of the pneumatic system

• Compressed air line and fittings must have a minimum diameter of 1/4in (7mm)

Compressed Air Plug (air in)

• The Vacuum is supplied with a 1/4in (7mm) industrial interchange compressed air plug for connection to your compressed air supply

The Compressed Air Plug may be changed to another nominal 1/4in (7mm) style if required.

• Hold the brass bulkhead fitting with a 1in (26mm) open end wrench

• Remove the compressed air plug with either a 9/16in (15mm)deep socket or 9/16in (15mm)open end wrench

• Install a new compressed air plug

Compressed Air Coupler (air out)

• The Vacuum is supplied with two 1/4in (7mm) brass high flow compatible industrial interchange compressed air couplers

• This coupler provides convenient pass through compressed air for an air tool connected to the vacuum

The Compressed Air Coupler may be changed to another nominal 1/4in (7mm) style if required.

• Hold the brass bulkhead fitting with a 1in (26mm) open end wrench

• Remove the compressed air coupler with a 3/4in (19mm) open end wrench

• Install a new compressed air coupler

Repair or Warranty Contact

Page 6

GETTING STARTED

onsumables, and Accessories