Advertisement
(8) Run "Start"→"All Programs"→"bRoad Lanner Wave"→" PCI GW-US54GXS Utility".
(9) SX-2000WG+ is listed after pressing "Refresh" button. Click on the required SSID
("Room1" for this manual) and select "Connect this site".
Required SSID is not listed
-
If the required SSID is not listed in the window, click on the "Refresh" button and wait for 1
minute.
If the required device server is not listed after pressing "Refresh" button, please check
-
If still not listed, please restart the SX-2000WG+ (Disconnect and connect the power cable).
the settings of Device Server.
Please wait 2 minutes to configurate wireless connection.
-
If still not listed, please go back to Step (a)-(c) in Section 3(2)
(10)
Check button name was changed to "More Setting", then click on "X"
All Rights Reserved. Copyright © 2008, Hitachi Software Engineering Co., Ltd.
15
Advertisement
