Minimum Clearances - Fast RHE Series Selection, Use, Installation And Maintenance Manual

for the components (three-way valves,
condensate drainage traps, etc.)
without which the correct functioning
of the unit can not be guaranteed;
In particular:
• a space of at least 200 mm
must be available for the trap in
correspondence with the condensate
drain (fig. 11).
Positioning of the
supporting brackets
The unit must be positioned on a
horizontal surface to avoid:
• the damage of the motor fan
a s s e m b l i e s c a u s e d by w e i g h t
imbalance
• the incorrect operation of the
condensate drain.
The unit and the coil and silencer
m o d u l e a r e e q u i p p e d w i t h " L "
supporting brackets for horizontal
installation.
The unit can be fixed by means of fins
bars by steel M6 of suitable length, blo-
washers
cked through nuts and
port brackets assembled to unit; it must
be used one bar for each bracket (n.6
bars in all). It is advisable to use fins
bars with resistancy class at least 4.6.
In alternative, can be used tiranti with
equal or higher mechanical resistency.
If they are used fins bars with hifh resi-
stancy (class 8.8 at least), it is possible
to use n.4 fins bars for the blocking of
unit, not connecting the central bra-
ckets.
N.B.: It is recommended to place
rubber dampers to decrease the
vibrations generated by the unit.
Selection, installation, use and maintenance manual
High effi ciency heat recovery unit with cooling circuit - RHE -

Minimum clearances

Ceiling
to sup-
Ceiling
200 mm
F M6
INS BARS
Panels for inspection and/or filters replacement
24
Ceiling or placed on the ground
F M6
INS BARS
fig.08
200 mm
fig.09
GB