Table of Contents
Advertisement
Available languages
Available languages
Before first use
•
All parts of the blender are to be thoroughly cleaned before being used
for the first time. (see Section: Cleaning).
•
Take out the required length of cable from the cable tidy on the base of
the blender and connect the device to the mains supply.
Switching on and off
Before you proceed, we need you to pay attention to the following notes:
•
Do not switch on the appliance when the jar or the bottle is empty.
•
Do not leave the appliance switched on continuously for more than two
minutes. After two minutes, switch off the appliance and allow it to cool
down for three minutes before switching it on again.
•
To switch on the appliance with continuous low speed, set the on/off
switch (1) to the "I" position.
•
To switch on the appliance with continuous high speed, set the on/off
switch (1) to the "II" position.
•
To switch on the appliance in pulse mode, set the on/off switch (1) to the
"P" position.
•
To switch off the appliance, set the on/off switch (1) to the "O" position.
Hints for use
Before you proceed, we need you to pay attention to the following notes:
•
Do not exceed the maximum mark on the juice level indicator.
•
Do not overload the appliance. Do not put too many ingredients into the
jar or the bottle at one time. If the motor stops, immediately switch off
the appliance, remove the mains plug from the wall socket and allow the
appliance to cool down for at least 10 minutes.
How to Use
15
Advertisement
Table of Contents
