Using The Pump - LG UD501KOJ5 Owner's Manual

OPERATION
12
!
NOTE
• If the water bucket is removed
immediately after turning off the
dehumidifier, the water remaining in the
heat exchanger may drip inside the water
bucket storage area. Remove the water
with a soft cloth.
• While cleaning, do not touch the water
detection device on the inside top of the
water bucket storage area.
• Clean the water bucket once a week
during use.
• If the ambient temperature is low, there is
less moisture in the air for the product to
remove.
• Unplug the product before removing the
water bucket. If the bucket is removed
while the product is operating, the
compressor stops. The fan operates for
another three minutes to clear the
remaining water inside the heat
exchanger and then also stops.
!
CAUTION
Watch pinch points to avoid injuring
fingers when installing the water bucket.
!

Using the Pump

The pump function provides continuous
drainage which can be enabled from the
control panel.
1
Unplug the product. Turn the hose cover at
the back of the product counterclockwise to
open it and reveal the pump hose
connector.
2
Insert the adapter on one end of the
included long pump hose into the pump
hose connector until it stops. Gently tug on
the hose to make sure the hose is secure.
3
Place the end of the long pump hose in a
nearby sink or drain. Secure the hose in
place to prevent it from falling out of the
sink.
Push hose in