Ascii-Fax Error Messages - Panasonic FP Series Technical Manual

Modem Control/Dial-up Connections

3.8.2 ASCII-Fax Error Messages

Termination Description
status codes
0-9 Start and termination of call
0
Connection terminated normally and correctly
1
Ring detected without successful handshake
2
Call aborted by +FK or AN
3
No loop current
10 - 19 Transmission phase A and various error messages
10
Unspecified error in transmission phase A
11
No response (T.30 T1 Timeout)
20-39 Transmission phase B, abort errors
20
Unspecified error in transmission phase B
21
Remote station cannot receive or send
22
COMREC error in transmission phase B
23
COMREC received invalid command
24
RSPEC error
25
DCS sent 3 times without response
26
DIS/DTC received 3 times; DCS not identified
27
Adaption error upon receiving 2400 bps or +FMINSP
28
RSPREC received invalid response
40-49 Transmission phase C, abort errors
40
Unspecified error in transmission phase C
43
DTE to DCE data flow interrupted
50-69 Transmission phase D, abort errors
50
Unspecified error in transmission phase D
51
RSPREC error
52
No response after MPS was repeated 3 times
53
Invalid response to MPS
54
No response after EOP was repeated 3 times
55
Invalid response to EOP
56
No response after EOM was repeated 3 times
57
Invalid response to EOM
58
Continuation impossible after PIN or PIP error
70-89 Reception phase B, abort errors
70
Unspecified error in reception phase B
71
RSPREC error
72
COMREC error
73
T.30 T2 Timeout, expected page not received
74
T.30 T1 Timeout received after EOM
90-99 Reception phase C, abort errors
90
Unspecified error in reception phase C
44
FP Modem-EU Technical Manual