Sony BDP-S6700 Faq page 2

o
Command Mode is used when multiple players are used with a single remote.
o On some players, Command Mode is listed under Options in the Setup menu.
11. Turn off the Light Sensor setting, if applicable.
0. On the TV, not on the remote control, press the HOME button.
1. Using the up or down arrow select Preferences.
2. Press the INPUT button.
3. Press the up or down arrow to select ECO.
4. Press the INPUT button.
5. Use the up or down arrow to select Light Sensor.
6. Press the INPUT button.
7. Press the or down arrow to select OFF.
8. Press the INPUT button.
12. Restore your device to factory default settings.
If the issue still occurs after following the instructions above, you can purchase a new remote
control online. Go to Parts and
No picture when I use an HDMI connection
Make sure your TV has the recent system software installed.
model support page.
1. Check which input on the TV the source device is connected to.
2. On the supplied TV remote control, press the INPUT button repeatedly until it displays
the correct HDMI® input where the source device is connected.
3. Disconnect the HDMI cable and then reconnect it. A bad connection may occur
temporarily and cause this issue.
4. If you're using an audio system such as amplifier or theater stand) between the TV and
your video source, make sure that the input setting on the audio system corresponds to the
video output source.
5. Make sure the connected device is set to output through its HDMI connection and the
video format being output is compatible with the TV.
o
The output signal set on your source device may be indicated on its display or in
its menus.
o
Some devices may output a 1080/24p or 1080/30p video signal, but some TVs can
only accept a 1080/60p video signal. Changing the video output format of the
connected device may resolve the issue. Check the manual or contact the
manufacturer for further information.
o
The A/V receiver may not up-convert a signal to HDMI if you connected an
analog connection type (Coaxial, Composite A/V, Component A/V, or S-Video)
on the output device and the audio system. Check the receiver manual for details
about other connection options.
6. If the device is connected to an A/V Receiver or other component before being connected
to the TV, try connecting directly to an HDMI input of the TV. If this works, your
Accessories.
Downloads are posted on your