Low Frq Test - Yamaha RX-V800RDS Owner's Manual

SET MENU
I 1D LFE/BASS OUT (bass out
mode)
LFE signals carry low-frequency effects when this unit
decodes a Dolby Digital or DTS signal. Low-frequency
signals are defined as 90 Hz and below.
Choices: SWFR (subwoofer), MAIN, BOTH
Initial setting: BOTH
SWFR
Select this if you use a subwoofer. The LFE signals are
directed to the subwoofer.
1D LFE/BASS OUT
SWFR
MAIN
Select this if you do not use a subwoofer. The LFE signals
are directed to the main speakers.
1D LFE/BASS OUT
SWFR
BOTH
Select this if you use a subwoofer and you want to mix
the main channel low-frequency signals with the LFE
signals.
1D LFE/BASS OUT
SWFR MAIN BOTH
Note
• The low-frequency signals (90 Hz and below) from all main,
center and rear channels are directed to the LFE channel when
you select the small speaker setting in items 1A, 1B and 1C.
42
MAIN BOTH
MAIN BOTH
I 1E MAIN LEVEL (main level
mode)
Change this setting if you cannot match the output level
of the center and rear speakers with the main speakers
because of the unusually high-efficiency performance of
the main speakers.
Choices: Normal, –10 dB
Initial setting: Normal
Normal
Select this if you can match the output level of your effect
speakers with that of your main speakers when using the
test tone.
1E MAIN LEVEL
Normal
–10 dB
Select this if you cannot match the output level of your
effect speakers with that of your main speakers when
using the test tone.
1E MAIN LEVEL
Normal

2 LOW FRQ TEST

Use this feature to adjust the output level of the
subwoofer so it matches that of the other speakers in your
configuration. Change the setting with the remote control
while sitting in the listening position.
1
Press j / i to set "TEST TONE" to ON, and
adjust the volume with VOLUME +/– so you
can hear the tone.
Notes
• Do not turn up the volume too high.
• If no test tone is heard, turn down the volume, set this unit in
the standby mode and make sure all the necessary connections
are correct.
–10dB
–10dB