Impedance Selector Switch; Connecting The Power Supply Cords - Yamaha RX-V800RDS Owner's Manual

IMPEDANCE SELECTOR Switch

WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise the unit
may be damaged.
If this unit fails to turn on when STANDBY/ON (or POWER) is pressed, the IMPEDANCE SELECTOR switch may
not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the standby
mode.
Select the left or right position according to the impedance of the speakers in your system. Be sure to move this switch
only when this unit is in the standby mode.
(Europe model)
MAINS
100W MAX. TOTAL
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B: 4 MIN. /SPEAKER MAIN A OR B: 8 MIN. /SPEAKER
A + B: 8 MIN. /SPEAKER A + B:16 MIN. /SPEAKER
CENTER : 6 MIN. /SPEAKER CENTER
REAR : 6 MIN. /SPEAKER REAR
IMPEDANCE SELECTOR

Connecting the Power Supply Cords

After completing all connections, connect the AC power cord to an AC power outlet. Disconnect the AC power cord if
you will not use this unit for a long period of time.
I AC OUTLET(S) (SWITCHED)
MAINS
100W MAX. TOTAL
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B: 4 MIN. /SPEAKER MAIN A OR B: 8 MIN. /SPEAKER
A + B: 8 MIN. /SPEAKER A + B:16 MIN. /SPEAKER
CENTER : 6 MIN. /SPEAKER CENTER
REAR : 6 MIN. /SPEAKER REAR
SWITCHED
Switch
position
AC OUTLETS
SWITCHED
Left
: 8 MIN. /SPEAKER
: 8 MIN. /SPEAKER
Right
(Europe model)
AC OUTLETS
SWITCHED
: 8 MIN. /SPEAKER
: 8 MIN. /SPEAKER
To AC outlet
Speaker Impedance level
If you use one set of main speakers, the impedance of
each speaker must be 4 Ω or higher.
Main
If you use two sets of main speakers, the impedance of
each speaker must be 8 Ω or higher.
The impedance must be 6 Ω or higher.
Center
The impedance of each speaker must be 6 Ω or higher.
Rear
If you use one set of main speakers, the impedance of
each speaker must be 8 Ω or higher.
Main
If you use two sets of main speakers, the impedance of
each speaker must be 16 Ω or higher.
Center The impedance must be 8 Ω or higher.
Rear
The impedance of each speaker must be 8 Ω or higher.
Europe model ............................................... 2 OUTLETS
U.K. model ..................................................... 1 OUTLET
Use these outlets to connect the power cords from your
components to this unit. The power to the AC
OUTLET(S) is controlled by this unit's STANDBY/ON
(or POWER and STANDBY). These outlets will supply
power to any connected component whenever this unit is
turned on. The maximum power (total power
consumption of components) that can be connected to the
AC OUTLET(S) is 100 W.
CONNECTIONS
19