Yamaha ACU16-C Owner's Manual page 2

Owner's Manual Addendum
Please make the following changes and additions to the ACU16-C/NHB32-C owner's manual. Some of
these are due to the ACU16-C/NHB32-C system software upgrade, while others are corrections and
supplementary explanations.
Changes due to the software upgrade
❏
Support for CobraNet "Low Latency" (system software v1.10)
In conjunction with the upgrade to system software V1.10, the latency setting that had been fixed at 5.33 ms can now be
selected from three choices (5.33 ms/2.67 ms/1.33 ms). This allows even lower-latency distribution of audio signals. In
addition, you can now make connections at the desired latency to digital mixers such as the PM5D or digital mixing engines
such as the DME64N/24N via the Yamaha "MY16-C" card.
Changing the latency can be done in conjunction with NetworkAmp Manager V1.1.0E. For the procedure, refer to the
NetworkAmp Manager owner's manual (PDF format).
The latency and audio bit depth settings will determine the limits on the number of channels that can be distributed in one
bundle, and the number of bundles that can be distributed.
• NHB32-C
Latency
Channels per
bundle
5.33ms
2.67ms
1.33ms
• ACU16-C
Maximum number of
Latency
bundles (input only)
5.33ms
2.67ms
1.33ms
If two or more different latencies exist in a CobraNet network, it may become impossible for the various devices to
communicate correctly. You must make sure that all CobraNet devices in a single network have the same latency setting.
Additions and corrections
❏
Cable Length & Switching Hubs
The maximum length of a cable used in a 100Base-T Ethernet network is 100 m (a maximum of 2 km for a multimode optical
fiber cable), but depending on the type of cable used and on the performance of the switching hub, there are cases in which
this length cannot be guaranteed. Three or four switching hubs can be connected, but this also will depend on the
performance of the switching hub.
❏
"System Requirements (NetworkAmp Manager)" (page 10)
The following items have been added to the operating requirements for NetworkAmp Manager.
• If your computer has HyperThreading Technology, you must disable it when connecting via USB.
• This software cannot be used on a computer that has multiple CPUs (e.g., Intel's Xeon processor or AMD's Opteron
processor).
• This software cannot be used on a computer that has a dual core CPU (e.g., Intel's Pentium-D processor or AMD's
Athlon64 x2 processor).
• This software cannot be used on a computer running Windows XP x64 Edition.
ACU16-C/NHB32-C
20-bit
Maximum number of bundles
(total of input and output)
8
8
8
4
4
4
Channels per
bundle
8
8
4
– 2 –
24-bit
Maximum number of bundles
(total of input and output)
7
8
8
8
8
4